PETG print settings and tips
Tougher and more heat-resistant than PLA, with a glossy finish. A good choice for parts that live outdoors or in a warm room, at the cost of a little more stringing.
At a glance
- Nozzle
- 240–255 °C
- Range to test
- 220–270 °C
- Bed
- 70–90 °C
- Density
- 1.27 g/cm³
- 1 kg of 1.75 mm
- ≈ 327 m
- 1 kg of 2.85 mm
- ≈ 123 m
In each slicer's profile
| Slicer | Nozzle | First layer | Bed | Fan | Max flow |
|---|---|---|---|---|---|
| Bambu Studio Bambu PETG HF @BBL P1S 0.4 nozzle | 245 °C | 230 °C | 70 °C | 20–40% | 21 mm³/s |
| OrcaSlicer Generic PETG @Creality | 255 °C | 255 °C | 80 °C | 40–90% | 10 mm³/s |
| PrusaSlicer Generic PETG @MK4S | 240 °C | 240 °C | 90 °C | 20–40% | 12 mm³/s |
As each slicer ships its profile for a 0.4 mm nozzle (Bambu Studio for the P1S, OrcaSlicer for the Creality K1, PrusaSlicer for the MK4S). The profile named after a brand is that brand's own filament.
Good for
- Outdoor signs, plant markers and garden parts
- Functional parts that must flex a little rather than snap
- Prints that sit in a warm room or a car
Not the best for
- Very fine detail and sharp overhangs, where PLA does better
- Parts that need a crisp matte look
Printing it well
- Slow the cooling fan: PETG bonds its layers better with less of it.
- It can bond very strongly to smooth PEI; a textured plate or a thin layer of glue stick makes prints easier to remove.
- If it strings, run the retraction test and keep the filament dry.
Tune it for your printer
Temperature tower · Retraction test · Flow rate test · What a print costs
Questions
What temperature should I print PETG at?
The slicers' own profiles print it at 240–255 °C on the nozzle, within a range of 220 to 270 °C. Print a temperature tower to find the best value for your brand.
What bed temperature does PETG need?
The slicer profiles heat the bed to 70–90 °C.
How many metres are on a 1 kg spool of PETG?
About 327 m of 1.75 mm filament, or 123 m of 2.85 mm, at a density of 1.27 g/cm³.
Is PETG stronger than PLA?
It is tougher: it bends before it breaks and copes with heat better. PLA is stiffer and holds sharper detail.
Why does PETG string so much?
It oozes more than PLA at printing temperature. Dry filament, the right retraction and a slightly lower temperature cure most of it.
Other filaments
Settings from each slicer's own filament profile, checked 2026-11-15.