TerraPrinterLaunched in March 2025
Make your own

How to fix elephant foot on 3D prints

Elephant foot is a lip that sticks out round the bottom few layers of a print. It spoils the fit of parts that slot together, such as puzzle pieces, bins in a baseplate and tiles, and it blurs the base of a model.

A first-layer test: squares in the corners and the middle of the bed

Why it happens

The first layer is squashed into the bed on purpose so it sticks. If it is squashed too hard, or the warm bed keeps the bottom layers soft while the weight of the print presses down, the bottom spreads outward.

Check the nozzle height

A nozzle set too close squeezes the first layer wide. Print the first-layer test: the lines should just touch and blend, not be scraped thin or ridged. Adjust the Z offset (or the live adjust on Prusa printers) a few hundredths of a millimetre at a time.

A slightly cooler bed

If the bottom stays soft, lower the bed temperature 5 °C, staying within what the filament needs to stick. The filament pages list the slicers' starting values.

Use elephant foot compensation

Slicers can shrink the first layer slightly to cancel the spread. It is Elephant foot compensation in PrusaSlicer, Bambu Studio and OrcaSlicer. Around 0.1 to 0.2 mm is typical; measure a test cube's bottom and top widths and set the difference.

A small chamfer helps too

A 0.4 to 0.6 mm chamfer on the bottom edge of a part hides any elephant foot that is left, which matters most for parts that slot together.

Questions

What is elephant foot in 3D printing?

A bulge round the bottom layers of a print, where the first layers are squashed outward.

How do I fix elephant foot?

Raise the nozzle slightly, lower the bed temperature a little, and use the slicer's Elephant foot compensation (about 0.1 to 0.2 mm).

More guides

All guides · Ready-made maps · 3D map gifts

Make it now, print it when you're ready

Free, no account needed, and free to sell, at any volume.

Open TerraPrinter

Reviewed 2026-10-30 against the live app.