How to fix elephant foot on 3D prints
Elephant foot is a lip that sticks out round the bottom few layers of a print. It spoils the fit of parts that slot together, such as puzzle pieces, bins in a baseplate and tiles, and it blurs the base of a model.
Why it happens
The first layer is squashed into the bed on purpose so it sticks. If it is squashed too hard, or the warm bed keeps the bottom layers soft while the weight of the print presses down, the bottom spreads outward.
Check the nozzle height
A nozzle set too close squeezes the first layer wide. Print the first-layer test: the lines should just touch and blend, not be scraped thin or ridged. Adjust the Z offset (or the live adjust on Prusa printers) a few hundredths of a millimetre at a time.
A slightly cooler bed
If the bottom stays soft, lower the bed temperature 5 °C, staying within what the filament needs to stick. The filament pages list the slicers' starting values.
Use elephant foot compensation
Slicers can shrink the first layer slightly to cancel the spread. It is Elephant foot compensation in PrusaSlicer, Bambu Studio and OrcaSlicer. Around 0.1 to 0.2 mm is typical; measure a test cube's bottom and top widths and set the difference.
A small chamfer helps too
A 0.4 to 0.6 mm chamfer on the bottom edge of a part hides any elephant foot that is left, which matters most for parts that slot together.