TerraPrinterLaunched in March 2025
Make your own

First layer not sticking? How to fix it

A good print starts with a first layer that goes down flat, even and firmly stuck. If lines drag around, curl up or the print comes loose part way, the cause is almost always one of a handful of things, in this order.

A first-layer test: squares in the corners and the middle of the bed

1. A clean plate

Fingerprints are the most common reason prints do not stick. Wash a PEI or textured plate with warm water and dish soap, rinse and dry it, and hold it by the edges afterwards. Isopropyl alcohol is fine between washes but does not remove everything.

2. The right nozzle height

Too high, and the lines lie round and separate and peel off. Too low, and the plate is scraped, with ridges or see-through lines. Print the first-layer test sized for your bed and adjust the Z offset until every square is smooth, with the lines just squashed together. Squares that differ across the bed mean it needs levelling.

3. The bed temperature and plate for the material

Each material wants its own bed temperature: the filament pages list what the slicers' own profiles use. PETG can bond so well to smooth PEI that it tears the surface; a textured plate or a thin layer of glue stick works as a release layer.

4. A slower, hotter first layer

Slicer profiles already print the first layer slower; if lines drag, slow it further. A first layer 5 °C hotter than the rest also helps it grip. Turn the part cooling fan off for the first layer or two (the profiles usually do).

5. A brim for small or tall parts

Small contact areas and tall, narrow parts have little to hold on with. A brim of 5 to 8 mm gives them a firm base and peels off afterwards.

Questions

Why is my first layer not sticking?

Most often a dirty plate or a nozzle set too high. Wash the plate with dish soap, then adjust the Z offset with a first-layer test.

What does a good first layer look like?

Smooth and even, with the lines slightly squashed into each other and no gaps or ridges.

Should I use glue stick?

On smooth PEI it helps PETG release rather than stick, and helps difficult materials grip. For PLA on a clean plate it is rarely needed.

More guides

All guides · Ready-made maps · 3D map gifts

Make it now, print it when you're ready

Free, no account needed, and free to sell, at any volume.

Open TerraPrinter

Reviewed 2026-10-30 against the live app.